4.4 INSTALLATION OF OPTION
4.4.1 FBA-44 ALKALINE BATTERY CASE
FBA-44 is a Battery Case that holds three "AAA" size Alkaline Batteries and
is used with the HX300E transceiver.
To insure the HX300E will not have a problem with water intrusion, make
sure the battery cover is properly installed and the battery latch is closed.
The power output will be reduced to "Low Power" (1 W) automatically
when using the FBA-44.
Install the three "AAA" size Alkaline Batteries into the
FBA-44 Battery Case with the Negative (–) side of the
batteries touching the spring connections inside the
FBA-44 Battery Case (Figure 1).
Turn over the FBA-44 Battery Case, then insert the
FBA-44 Battery Case into the Battery Compartment,
by a same manner of the installation of the FNB-122LI
(Figure 2).
Re-install the Battery Cover (Figure 3), then close the
Battery Cover Latch until it locks in place with a "Click"
(Figure 4).
F
igure
The FBA-44 is designed for use only with "AAA" size Alkaline
Cells. Do not attempt to install any rechargeable battery cell.
If you do not use the HX300E for a long time, remove the Alkaline
batteries from the FBA-44, as battery leakage could cause dam-
age to the FBA-44 and/or HX300E.
HX300E
CAUTION
IMPORTANT NOTE
2
NOTE
F
3
igure
F
1
igure
F
4
igure
Page 15