Table of Contents
Advertisement
*1 Error Condition Alarm Mode
If an error condition is detected during operation, the printer will stop printing
and cause the FaUlt signal to go MaRk. all solenoides & motors will be de-
energized. It is necessary to turn the printer power off and on again in order to
recover from the alarm mode.
This printer can detect the following error coditions:
a. Motor lock
b. Defective timing detector
c. Micro-proccessor out of program sequence
8-6. Interface Connections
For interface connections, refer to the instructions for interface of the host com-
puter. The following gives one basic example of connections.
Figure 8-5. D-Sub 25 Pin Connector
Figure 8-6. Interface Connections
with D-Sub 25 Pin Connector to IBM PC
– 30 –
Advertisement
Table of Contents
