Table of Contents
Advertisement
4-3-3. Validation Option Installation
The validation printing requires the optional printer cover 8340R. Refer to item
4-3-2 for the installation.
(1) turn power ON.
(2) enter the printer the validation mode.
(Refer to the control code "GS" in Chapter 5.)
(3) Insert the material to be validated against the right side of the slot in the
Printer Cover 8340R.
4-4.
Roll Paper Removal
Cut the paper close to the slot and use the feed button until paper has passed
completely through the printer.
Note: Do not try to remove the paper by hand as it could become crooked and
get jammed inside the printer.
Figure 4-8. Insertion of Material to be validated
– 13 –
Advertisement
Table of Contents
