Advertisement
3. CONTROL ELEMENTS
3-WAY MONO
To work in this mode, configure your system and connect cables as follow:
1. Press the
MODE
2. Feed a mono signal from the Mixer to the input connector of CH1.
3. Output the Low frequencies signal via OUT LOW 1 to the power amplifier
dedicated to the woofers.
4. Output the Mid frequencies signal via OUT LOW 2 to the power amplifier
dedicated to the midrange.
5. Output the High frequencies signal via OUT HIGH 2 to the power amplifier
dedicated to the high frequency transducer.
6. Set LOW-HIGH Crossover Range of channel1 to x1 (switch disengaged) and
select the desired crossover frequency. This channel will crossover low and
mid frequencies.
7. Set LOW-HIGH Crossover Range of channel 2 to x10 (switch engaged) and
select the desired crossover frequency. This channel will crossover mid and
high frequencies.
8. Power up your X23 first, then the power amplifiers. After use, please ensure
the power amplifier is turned off first, then your X23.
Rated Power Consumption 8.5W
FUSE:
210-240V: T100mAL 250VAC
95-120V: 200mA 250VAC
REPLACE FUSE WITH CORRECT
TYPE ONLY
2WAY- STEREO
/
( 3WAY- MONO)
A101
DESIGNED IN ITALY
MADE IN CHINA
4. APPLICATIONS
switch to enter into the 3-way mono mode.
HIGH
MID
ON
OFF
POWER
HIGH
PHASE
HIGH OUT 2 / (HIGH OUT)
LOW OUT 2 / (MID OUT)
CHANNEL 2
MAC 2.4
Stereo Power Amplifier
ON
CH1
OFF
POWER
R
LTO
MAC 2.4
Stereo Power Amplifier
CH1
CH2
POWER
PROT
CLIP
SIG
PUSH
STEREO MONO
NEW
TIDE
CD
3
BOOST
MODE
2
1
INPUT 2 / (NOT USED)
HIGH OUT 1 / (NOT USED)
LOW
R
LTO
CH2
POWER
PROT
CLIP
SIG
HIGH
CD
PHASE
BOOST
LOW OUT1 / (LOW OUT)
CHANNEL 1
PUSH
NEW
TIDE
3
2
1
INPUT 1 / (INPUT)
5
Advertisement
