Heat & Glo SOLARIS36-ST Owner's Manual page 66

B. Vent Components Diagrams (continued)
Note: Heat shields MUST overlap by a minimum of 1-1/2 in. (38 mm). The heat shield is designed to be
used on a wall 4 in. to 7-1/4 in. (102 mm to 184 mm) thick. If wall thickness is less than 4 in. (102 mm)
the existing heat shields must be field trimmed. If wall thickness is greater than 7-1/4 in. (184 mm) a
DVP-HSM-B will be required.
15-1/8 in.
(384 mm)
12 in.
(305 mm)
SL-2DVP
Adapter
DVP-HSM-B
Extended Heat Shield
Figure 16.4 SLP Series Vent Components
66
8 in.
(203 mm)
SLP-TRAP
Horizontal Termination Cap
26 in.
660 mm
Heat & Glo • Solaris • 2179-900 Rev. E • 4/11
Heat
Shield
Term Cap
Max
Effective
Trap1
Length
Trap2
SLP-TVHW
Vertical
Termination Cap
(305 mm)
14 in.
(356 mm)
DVP-WS (Wall Shield Firestop)
Minimum Maximum
Effective Length Effective Length
3-1/8 in. 4-3/4 in.
79 mm 121 mm
5-1/4 in. 9-1/4 in.
133 mm 235 mm
DVP-FBHT
Horizontal
Termination Cap
12 in.
1 in.
(25 mm)
8 in.
(203 mm)
6 in.
(152 mm)