Table of Contents
Advertisement
1. B
EFORE
What is included
1 x Abyss™ LED
1 x Power Cord
1 x Warranty Card
1 x User Manual
Unpacking Instructions
Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that
all parts are present, and have arrived in good condition. Notify the shipper immediately and retain
the packing material for inspection if any parts appear damaged from shipping or the carton shows
signs of mishandling. Save the carton and all packing materials. In the event that a fixture must be
returned to the factory, it is important that the fixture be returned in the original factory box and
packing.
Symbols
This paragraph contains critical installation, configuration or operation information. Failure to comply
with this information may render the system partially or completely inoperative, cause damage to the
system or cause harm to the operator/user/technician
This paragraph contains important installation or configuration information. Failure to comply with this
information may prevent the system from functioning correctly.
This paragraph reminds you of useful, although not critical, information.
AC Power
Verify that the voltage select switch on your unit matches the line voltage applied. Damage to
your fixture may result if the line voltage applied does not match the voltage indicated on the
voltage selector switch.
Always connect the fixture to a switched circuit. Never connect the fixture to a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only as a
0% to 100% switch.
To determine the power requirements for a particular fixture, see the label
affixed to the back plate of the fixture or refer to the fixture's specifications
chart. A fixture's listed current rating indicates its average current draw under
normal conditions.
Before applying power to a fixture, check that the source voltage matches the
fixture's requirement. Check the fixture or device carefully to make sure that if
a voltage selection switch exists, it is set to the correct line voltage you will
use.
Always connect the fixture to a circuit with a suitable electrical ground.
Abyss™ LED User Manual
Y
B
OU
EGIN
1
Figure 1 - AC Voltage Switch
Not all fixtures have a
voltage select switch.
Please be sure to connect
to the proper voltage.
6/1/2009 11:15 AM
Advertisement
Table of Contents
