Complete The Installation - Vermont Castings RUVSOD Series Homeowner's Installation & Operating Manual

Right Rear Log
Left Rear Log
Left Bracket
LG171
Fig. 23 Install the left and right rear logs and the right log.
LG156
Radiance logs
4/23/01 djt
Log rests on
decorative grate
Fig. 24 Completed log installation. LG155
5. Loosely sprinkle the lava rocks directly on top of the
Radiance logs
burner just behind decorative grate. (Fig. 25) Use
installed
the lava rock to cover brackets on the burner. Do
4/24/01 djt
not place lava rocks toward back of burner. The lava
rock is shipped inside the bag assembly.
Left Rear Log
Top View
Decorative Grate
LG160
Fig. 25 Lava rock placement.
20004555
Right Log
Decorative
Right Bracket
Grate
Lava Rock
Right Rear
Log
Lava rock may
be placed in this
area
LG160
RNV logs
top view
6/4/01 djt
1. Replace the screen frame by sliding the hooks over
the top front edge of the firebox and resting the bot-
tom on the support brackets. If the catalyst has been
installed, place the glass front on the stove by rest-
ing the bottom edge of the frame on support brack-
ets below the front opening of the firebox. Swing the
top edge of the assembly toward the firebox, and
center it. Fasten it by closing the latches over the top
left and right edges of the frame.
2. Replace the stove front by grasping it by the left and
right edges. Lift it so that tabs on the back side of
the top corners engage notches at the top forward
corners of the stove sides. Then gently swing the
bottom of the front panel to a vertical position, and
lower it till prongs on its bottom left and right corners
engage with notches cast into the tops of the forward
legs. (Fig. 26) Test that the front is installed securely
by grasping two of panel's vertical bars, and pulling
the panel toward yourself. When the panel is in place
properly you should not be able to pull the bottom of
the front toward yourself without also lifting it.
3. Attach the wooden handle to the control door using
the #8-32 x 2" screw from the parts bag. (Fig. 27)
4. Set the screen and the cast-iron grate into the re-
cess in the stove top.
This completes the installation and assembly of the
Radiance RUVSOD.
LG172
Fig. 26 Replace the front panel.
Fig. 27 Attach the handle to the control door.
Radiance Vent-Free Gas Heater

Complete the Installation

ST139a
Radiance
replace front
7/24/01 djt
ST197
RUVS attach accessory door handle
7/01
ST139a
ST197
15