Settings; Default Settings (May Be Depending On Your Country's Version); Returning The Settings To Their Default Values (Reset); Aeg Spirit 100 05.06 Gc_De - AEG Spirit 100 User Manual

SETTINGS

You can change the parameters for a number of settings as described below.
These parameters can be returned to their original values by a RESET.

Default settings (may be depending on your country's version)

The following parameters are preset in the factory:
Ringer volume at the base
Ringer melody at the base
PIN Code
Dialing mode
Flash - time
Ringer volume at the handset
Ear piece volume
Internal melody
External melody

Returning the settings to their default values (RESET)

Proceed as follows, to make a reset:
1. Open the battery compartment and remove a battery.
2. Hold the star - key " " and re-insert the battery. Make sure the polarity is
correct.
3. Hold the star – key " ", until the whole display fills with the digit "8".
Press the programming key P, you hear a short confirmation signal at the
4.
handset. After approximately 5 seconds, the handset switches OFF, and
you hear a confirmation signal at the base.
5. The handset switches back on automatically, and registers to the base.
All parameters are reset to the factory settings.
Also the CID – list, the redial – list, the phonebook and the direct dial memories
are emptied.
This user manual is made for your information. Its contents are no
part of the contract. All technical data refer only to the normal val-
ues. Described execution and options can be different, depending
on the local requirements of your country.
We reserve the right to technical modifications!
14
3
2
0000
1: MFV (tone dialing)
2: (300ms)
3
3
1
3
888888888888

AEG Spirit 100 05.06 gc_de