NEC iS15-2K User Manual page 5

Cinema Projector: User Manual
iS15-2K
Installation precautions
Connect the LAN cable only to a computer LAN connection. Other
similar connectors may have a dangerously high voltage source.
A ferrite-core clamp must be fitted to each SDI cable used, to ensure
protection from radio frequency interference.
The projector must be installed only by suitably qualified personnel, in
accordance with local building codes.
The projector should be installed as close to the power outlet as
possible.
The power connection should be easily accessible, so that it can be
disconnected in an emergency.
Ensure that there is at least 30cm (12in) of space between the
ventilation outlets and any wall, and 10cm (4in) on all other sides.
Do not install the projector close to anything that might be affected by
its operational heat, for instance, polystyrene ceiling tiles, curtains etc.
If the projector must be mounted close to people or heat sensitive
equipment, then external ducting will be required to remove the hot
exhaust air safely.
For more information about external ducting, see Fitting the lamp duct box,
in section 6. Installation.
The projector weighs over 100kg (200lbs). Use safe handling
techniques when lifting the projector.
Before installation, make sure that the surface that is to support the
projector is capable of supporting the combined weight of the projector
and lens (see specification for exact weights).
Do not place heavy objects on top of the projector chassis. The
projector chasis is NOT capable of withstanding the weight of another
projector.
Do not drop or jarr the projector.
Place the projector in a dry area away from sources of dust, moisture,
steam, smoke, sunlight or heat.
Each time a new lens is fitted to the projector, or the zoom drive lever is
operated, the calibration procedure MUST be carried out. See Using the
Menus in Section 4. Controlling the projector.
The zoom drive mechanism should always be set to the engaged
position, even when using the non-zoom lens, as it provides an extra
level of protection, should the lens release lever fail.
Installation of the lamp duct box should be carried out ONLY by
certified service personnel.
Do not tilt the projector more than ±12° from side to side when in use,
as this may cause serious lamp failure, damage the lamp module and
cause extra cost on replacement. The projector my be tilted forwards
and backwards as necessary.
page iii
Important Information
Notes
±12°
360°