Adjust The Leg Levellers; Adjust Air Deflector; Attach Flue Collar Heat Shield; Attach The Damper Handle - Vermont Castings Defiant 1975 Installation And Operating Manual

Non-catalytic / catalytic woodburning stove
Table of Contents

Advertisement

adjust the leg levellers

Lift the stove slightly so there is no weight on the leg
while making the adjustment.
Reverse the Flue collar (if necessary)
Reverse the flue collar by removing the two screws that
attach it to the back of the stove. Be sure the gasket
around the flue collar opening is in position when you
screw the collar back onto the stove.

adjust air Deflector

If you have the optional fan kit, you may decide to
adjust the air deflector to blow heat across the top of
your stove. (Fig. 24) Loosen the two (2) screws on each
side and raise or lower the deflector. After adjustment,
tighten the screws.

attach Flue collar heat Shield

waRNiNg: The flue collar heat shield must be attached
to the Defiant stove. Use four #10 sheet metal screws
supplied to secure the flue collar heat shield to the rear
of the stove. (Fig. 24)
Air Deflector
Sheet
Metal
Screws
Flue Collar
Heat Shield
Fig. 24 Install flue collar heat shield.
waRNiNg: Flue collar heat shield must be installed.
30005220
Defiant
Air Deflector
Sheet
Metal
Screws
ST1180
ST1180
flue collar heat shield
1975 Non-Catalytic / Catalytic Woodburning Stove
®

attach the Damper handle

Use the 1/4" -20 x 3" screw to attach the damper handle
to the damper stub on the left side.
attach the primary air Thermostat handle
The primary air thermostat handle is the smaller of the
two black handles. Secure the handle to the stub on
the right side of the stove with an 8-32 x 2" slot head
machine screw. (Fig. 25)
assemble the Removable insert handle
The ceramic removable insert handle opens and closes
the front doors. Remove after each use, and store it in
the handle holder behind the right front leg. Assemble
the handle by passing the 3C\," screw through the
ceramic shaft and into the bright metal nub. (Fig. 26)
Tighten carefully until snug.
Fig. 25 Attach the thermostat handle.
ST539
attach
thermostat
handle
11/00
Fig. 26 Assemble the front door handle.
ST540
Assembly
handle
11/00
ST539
ST540
19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents