Life Fitness Smart Series Owner's Manual page 11

3.2 P
ACKAGING
Parts: None
Remove all packaging and place main components to the side of the box. Break box down in each of the four corners.
3.3 A
SSEMBLE THE
Parts: Hardware Bag #1
Tools: 5mm Hex Head Wrench
Locate and install the two LEVELER FEET (A) to the bottom of the REAR STABI-
LIZER (B).With the bends facing rearward, attach the REAR STABILIZER (B) to the
BASE UNIT (C) using two 50mm BUTTON HEAD SCREWS (1) from the top of the
REAR STABILIZER BRACKET (D) and two 15mm BUTTON HEAD SCREWS (2)
from the front side of the REAR STABILIZER BRACKET. Tighten the SCREWS
securely.
3.4 S H
ECURE ANDLEBAR
Parts: Hardware Bag #2
Tools: 5mm Hex Head Wrench, Phillips Screwdriver
Locate the HANDLEBAR ASSEMBLY (E) and the SEAT ASSEMBLY (F). With the handlebars facing upward and for-
ward, align the mounting holes of the HANDLEBAR ASSEMBLY with those in the SEAT ASSEMBLY. Secure the HAN-
DLEBAR ASSEMBLY to the SEAT ASSEMBLY using four 15mm BUTTON HEAD SCREWS (2) and FLAT WASHERS
(3). Tighten the SCREWS securely. Connect the CONNECTOR (G) leading from the HANDLEBAR ASSEMBLY (E) with
the CONNECTOR (G) leading from the SEAT ASSEMBLY (F). Be sure the connectors fully lock.
Locate the SEAT BOTTOM (H). Align the SEAT BOTTOM mounting holes with those in the LOWER SEAT SUPPORTS
(J). Secure the SEAT BOTTOM using four 55mm PHILLIPS SCREWS (4) and LOCK WASHERS (5). Tighten the
SCREWS securely.
10
R S
EAR TABILIZER
(2, 50mm Button Head Screws)
(2, 15mm Button Head Screws)
A
SSEMBLY TO
(4, 15mm Hex Head Bolts)
(4, 55mm Phillips Screws)
(4, Lock Washers)
(4, 18mm O.D. Flat Washers)
S A
EAT SSEMBLY