Bandsaw Unit; Sliding Rails - Grizzly G5787 Instruction Manual

Meatcutting bandsaw with sliding table
Hide thumbs Also See for G5787:
Table of Contents

Advertisement

Bandsaw Unit

To install the bandsaw unit onto the stand:
1.
Place the bandsaw unit onto the stand as
shown in Figure 16. Get help so you do not
strain yourself.
Figure 16. Bandsaw unit onto stand.
2.
Line up the holes on the stand with the holes
on the bottom of the bandsaw unit.
3.
Fasten the stand to the bandsaw unit with
the hexagonal shaft and
shown in Figure 17.
Figure 17. Installing hexagonal shaft.
-14-
1
" washer as
2

Sliding Rails

To install the sliding rails:
1.
Roll pins should already be in the rails. Line
these up to their respective holes in the
bandsaw unit as shown in Figure 18.
Figure 18. Rails onto bandsaw unit.
2.
Fit the roll pins inside the holes. If they will
not fit, roll the rail over and try the other side.
Because the roll pins are slightly flared, they
will often only fit on one side.
3.
Tap the roll pins down into the holes with a
hammer so they are flush with the top sur-
face of the rail.
4.
Place the
1
"-12 x
2
rails and fasten the
ers underneath so that the rails are secured
to the bandsaw unit.
G5787 Meatcutting Bandsaw
3
" cap screws into the
4
1
" hex nuts with wash-
2

Advertisement

Table of Contents
loading

Table of Contents

Save PDF