Talk Group Id Hold; Turning An Id Sub-Bank On Or Off; Locking Out Talk Group Ids - Grecom PSR-300 Owner's Manual

Notes:
• If you made a mistake in Step 4, Invalid ID value appears and the scanner
beeps when you press ENT. Start again at Step 3.
• You can enter either a decimal or AFS code for ED (EDACS) IDs. The default
setting is decimal ID entry. When you press FUNC then 2, AFS Format ap-
pears for about 2 seconds. Now you can enter the ID code with AFS format.
If you entered an ID code that is already stored in same bank's ID channel,
Dupl. ID of X-XX appears. If you want to store the ID code, press ENT. To cancel
the operation, press CL.

Talk Group ID Hold

You can set your scanner to follow a trunking signal that you want to track
during scanning. While the scanner is stopped on a voice channel (VC ap-
pears), hold down TRUNK until ID hold ON. appears.
When ID hold is activated and the scanner receives a voice channel, the scan
indication S at the first digit in the top line changes to H.
To release ID hold, press SCAN or TRUNK.

Turning an ID Sub-Bank On or Off

Follow these steps to turn the ID sub-bank on or off during the program mode:
1 Press TRUNK repeatedly to select the desired sub-bank.
2. Press FUNC then 1 to turn the sub-bank on if it is off or off if it is on.
Follow these steps to turn the ID sub-bank on or off during the scan mode.
Note: This function activates when the receiving channel bank is closed
mode.
1. Press FUNC while the scanner is stopped on a voice channel transmission.
2. Press TRUNK. The display indicates which sub-bank is turned on or off. The
active sub-bank number appears.
3. Press FUNC and the number of the sub-bank you desire to turn on or off.
For example to turn sub-bank 4 on or off, press FUNC. Then press 4.

Locking Out Talk Group IDs

1. Press PGM.
Note: You can only lock out talkgroup IDs when the scanner is in the closed
mode (see "Open and Closed Modes").
2. Press TRUNK.
3. Press FUNC, or to move to the desired bank.
53