Searching Active Frequencies In A Range; Using Seek Search - Grecom PSR-300 Owner's Manual

Searching Active Frequencies in a Range

You can program the desired frequency range for a search.
1. Repeatedly press SRCH to select SR7.
2. Press PGM then SRCH. Enter SR7 Search Range Limits: appears and the
cursor blinks L on the fourth line for the lower-end limit frequency.
3. Use the number keys and •/DELAY to enter the desired lower-end limit fre-
quency (including the decimal point).
4. Press ENT to set the frequency. The cursor moves to U. If the entered fre-
quency is incorrect, Invalid Freq. briefly appears.
5. Enter your desired upper-end frequency and press ENT.
6. Press SRCH to start searching.
7. Rotate SQ clockwise and leave it set to a point just after the rushing sound
stops. When the scanner finds an active frequency, it stops searching.
Note: You can copy and save a frequency into a specified bank, channel, or
priority channel when the scanner finds an active frequency. See "Using Fre-
quency Copy" to save the frequency. The frequency copy works only in search
banks 1 through 7.
Search Notice:
You can set Zeromatic on or off by pressing FUNC then 0. Press FUNC then 0
again to reverse the Zeromatic setting. Whenever this feature is turned on,
Zeromatic ON. briefly appears then ZM appears at the right of the third line
and the scanner stops at the correct frequency. When you turn this feature off,
ZM changes to small caps (zm) and the scanner stops when it detects an
active signal. Zeromatic functions only in search banks 3, 4, 5, 6, and 7.
There are several group banks in SR3 Public Safety, SR4 Aircraft, and SR5
Amateur bands. You can turn off or on the groups by pressing the group num-
bers. For example to turn off 0, press 0.
In the Railroad and Limit search bands, press FUNC then press
searching up from the lowest frequency or press
from the highest frequency.
If you press PSE while searching, the scanner stops searching and *** PAUSED
*** appears. Press PSE again, and the scanner resumes searching.

Using Seek Search

While the scanner is searching, you can use the seek search by pressing FUNC
then 7. Seek Search ON. appears about 3 seconds on the bottom line. The
scanner stops at an active frequency for five seconds and restarts searching
automatically. The scanner repeats this operation. While seek search is acti-
vate, appears at the 3 line.
rd
to start searching down
to start
31