Setting And Starting A Washing Programme - AEG FAVORIT 55210 User Manual

Programme
1) For programmes where the option has an impact, the energy saving is between 10% and 25%.
2) During the 'Auto' washing programme the level of soiling on the dishes is determined by how cloudy the water
is. The programme duration, water and energy consumption levels can vary; this depends upon if the appliance
is fully or partially loaded and if the dishes are lightly or heavily soiled. The temperature of the water is
automatically adjusted between 45°C and 70°C.
3) Test programme for test institutes. Please refer to separate leaflet supplied, for test data.
Consumption values
Programme
30 MIN
1) The digital display shows the programme duration.
The pressure and temperature of the water, the variations of power supply and the quantity
of dishes can change these values.

SETTING AND STARTING A WASHING PROGRAMME

Set the washing programme with the door ajar. The washing programme only starts after
you close the door. Until then it is possible to modify the settings.
Do these steps to set and start a washing programme:
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press one of the programme buttons. Refer to the chapter 'Washing programmes'.
– The programme indicator light comes on.
– All other programme indicator lights go off.
– The digital display shows in flashing the programme duration.
– The phase indicator light for the washing programme starts to flash.
4. Close the door.
– The washing programme starts automatically.
– The phase indicator light for the washing programme is on.
Setting and starting a washing programme
Degree Type of
of soil load
Crockery
Normal
and cut-
soil
lery
Programme duration
(in minutes)
1)
-
-
-
-
Programme description
Prewash
Main wash up to 40°C
1 intermediate rinse
Final rinse
Energy consumption
(in kWh)
0,5-0,8
0,63
0,45
0,4
15
Energy
Save op-
1)
tion
Selectable,
no impact
on washing
pro-
gramme.
Water consumption
(in litres)
5-9
7
6
6