Table of Contents
Advertisement
ON/OFF SWITCH
1.
To turn the tool ON, slide the ON/OFF
switch (1) toward the front of the tool
(Fig. 5).
2.
To turn the tool OFF, slide the
ON/OFF switch toward the rear of the
tool.
LED WORKLIGHT
This tool is equipped with an LED worklight
(Fig. 6). The worklight (1) will automatically
turn ON when the tool switch is turned ON.
It will turn OFF when the tool switch is
turned OFF.
SPEED CONTROL DIAL
The speed of the tool can be adjusted to
run the tool at speeds varying between
11,000 OPM and 20,000 OPM by rotating
the speed control dial (1) located toward
the rear of the tool housing (Fig. 7).
1.
To increase the speed, rotate the
speed control dial clockwise.
2.
To decrease the speed, rotate the
speed control dial counter clockwise.
NOTE: Speed #1 is the lowest speed.
Speed #6 is the highest speed.
The optimal speed setting will vary
depending upon the type of accessory
being used, the surface being worked and
the complexity of the project. For general
recommendations, see the chart on the
following page.
ASSEMBLY AND OPERATING
14
Fig. 5
Fig. 6
Fig. 7
Hide quick links:
Advertisement
Table of Contents
