Sunrise Medical Quickie RX Owner's Manual page 34

Chair adjustments
Wheelbase (RXS)
To adjust the rear wheelbase
(Fig. 38), loosen the inner (1) and
outer (2) axle sleeve retaining
28mm A/F nuts. Screw the nuts
along the axle sleeve (3) until the
desired wheelbase is found.
Tighten the nuts with a torque
wrench to a setting of 45Nm.
Warning
Always ensure that there is
sufficient clearance between the
wheel and the frame after carrying
out this adjustment.
Centre of gravity (RXS)
The cente of gravity (Fig. 39) is
adjusted by removing the four
retaining nuts (1) and screws (2)
from the axle plate (3), sliding the
axle plate along the top and bottom
frame members (4) to the required
position and refitting the nuts and
screws in the predrilled holes (5) in
the frame. The spanner size is
10mm A/F, the screws and nuts
must be tightened to 8-10Nm
torque.
Note:
After changing the centre of gravity
always check:
Angle of castors (see page 32,
Fig. 42).
Both axles are in identical positions.
RX/RXS
1
Fig. 38
1
Fig. 39
30
2
3
4
2
3
4
5
Issue 5