Antec NeoPower 650 Blue User Manual page 3

3. One set of cables with a 6-pin PCI Express graphic card connector at one end
and a 6-pin PSU connector at the opposite end.
4. Two sets of cables with two SATA drive connectors at one end and a 6-pin
PSU connector at the opposite end.
Installation:
1. Install the NeoPower® PSU into your case with the four screws provided.
NOTE: Please also refer to your motherboard user guide for any special instructions.
NOTE: NeoPower and Quiet Computing are registered trademarks of Antec Inc
2. Connect the 24-pin Main connector to your motherboard.
1
2
2