Grizzly EXTREME G0605X Owner's Manual page 39

Extreme series 12" table saw
Hide thumbs Also See for EXTREME G0605X:
Table of Contents

Advertisement

To cut rabbets with the standard blade:
Note: Cutting rabbets with a standard saw blade
DOES NOT require the use of a sacrificial fence.
Note: Reduce motor overloading and blade wear
by using a ripping blade. Ripping blades are
designed to clear the sawdust quickly.
1.
DISCONNECT THE SAW FROM POWER!
2.
Ensure that the riving knife is installed.
3.
Clearly mark the width of the rabbet cut on
the workpiece.
Note: Include marks on the edge of the
workpiece to clearly identify the intended cut
while it is laying flat on the saw table.
4.
Raise the blade up to the desired depth of cut
(depth of rabbet channel desired). When cut-
ting deep rabbets, take more than one pass
to reduce the risk of kickback.
The danger of kickback increases relative to
the depth of a cut. Reduce the risk of kick-
back by making multiple passes to achieve
the desired depth of cut. Failure to follow
these warnings could result in serious per-
sonal injury.
5.
Adjust the fence so the blade is aligned with
the inside of your rabbet channel as shown in
Figure 52.
Figure 52. Rabbet cutting with a standard blade.
G0605X/G0606X Extreme Series 12" Table Saw
6.
Reconnect the saw to the power source and
turn the saw ON.
7.
When the blade has reached full speed, per-
form a test cut with a scrap piece of wood.
8.
If the cut is satisfactory, repeat the cut with
the final workpiece.
9.
Stand the workpiece on edge as shown in
Figure 53.
Figure 53. Second cut to create a rabbet.
10. Adjust the saw blade height to intersect with
the first cut.
11. Perform the second cut to complete the rab-
bet.
-37-

Advertisement

Table of Contents
loading

This manual is also suitable for:

Extreme g0606xG0605x/g0606x

Table of Contents