Table of Contents
Advertisement
• When you have set the HTTP port number to a number other than 80 on the Network setting
page or in the Setup Program, access the camera by typing the IP address of the camera on
the web browser as follows:
Example: when HTTP port number is set to 2000
PPPoE
Use this when you connect the camera through PPPoE (Point -to- Point Protocol over
Ethernet). PPPoE connection is the protocol that is widely used in xDSL (digital affiliate line
such as ADSL, VDSL or SDSL) as the authentication and connection system.
IP address：The IP address obtained at the PPPoE connecting with network.
User ID：Enter the user ID for authentication necessary for PPPoE connections. Type it up to
64 characters.
Password：Enter the password for authentication necessary for PPPoE connections. Type it
up to 32 characters.
Re-type password：Re-type the password to confirm.
Obtain DNS server address automatically：Select this to obtain the address of DNS server
automatically.
Use the following DNS server address：Select this when you set the fixed address as the IP
address of DNS server.
Primary DNS server：Enter the IP address of the primary DNS server.
Secondary DNS server：Enter the IP address of the secondary DNS server.
http://192.168.0.100:2000/
Advertisement
Table of Contents
