Table of Contents
Advertisement
Reboot：Click this button to reboot the camera. A confirmation dialogue will appear. Click OK
to proceed. It takes about two minutes to reboot the camera.
Factory default：Click this button to reset the camera to the factory default settings. A
confirmation dialogue will appear. Click OK to proceed, the network indicator on the camera
will start to blink. After completing adjustments to the default settings, the camera will reboot
automatically. Do not turn off the camera until the camera reboots.
Backup setting data：Save the setting data of the camera to a file. Click Save, and follow the
instructions on the browser to save the setting data file to your specified location.
Restore setting：Load the saved setting data of the camera. Click Browse and select the file
in which the setting data is stored. Click OK, and the camera is adjusted according to the
loaded data and restarted.
Firmware update：Upgrade the camera software. Click Browse and select the file for
upgrading. A confirmation dialogue will appear. Click OK to start upgrading. The camera will
reboot upon completion.
Note:
• Use only upgrade files that are special for this camera. Problems may occur otherwise.
• Do not turn off the camera power or disconnect the network until the upgrading is completed.
Advertisement
Table of Contents
