Motor - Grizzly & G1022PROZX Instruction Manual

Motor

NOTICE
Motor pictures shown are specific to the
Models SM & Z. The Models ZF, ZFX, PROZ,
& PROZX will look different but will assem-
ble in the same way.
To mount the motor:
1. Turn the motor upside down and attach the
motor plate using M8-1.25 x 25 hex bolts,
8MM flat washers and M8-1.25 hex nuts as
shown in Figure 15. Finger-tighten only.
The motor comes
pre-wired.
Figure 15. Attaching the motor plate.
2. Insert the 1 ⁄ ''-20 x 2'' hex bolt through the
4
hole in the pulley guard bracket as shown in
Figure 16.
-22-
Motor Mount Plate
1
⁄ ''-20 x 2'' Hex Bolt
4
Figure 16. Pulley guard bracket.
3. Set the motor on end and slip the pulley
guard bracket between the base of the motor
and the motor plate as shown in Figure 17.
Pulley Guard Bracket
Motor Mount Plate
Figure 17. Installing pulley guard.
4. Tighten 1 of the 4 mounting bolts. Leave the
other 3 loose.
5. Locate the motor mount bracket shown in
Figure 18. Loosen the setscrew that holds
the motor pivot rod in place and remove the
rod.
Pulley Guard Bracket
G1022 Series Table Saws