Care And Use; Warranty Information - Emerson Insinkerator C1300 Owner's Manual

ADJUSTING THE THERMOSTAT
Factory temperature pre-set is
200˚F. To reset the thermostat
to 200°, turn the indicator two
notches to the right of vertical.
I I
Adjust the thermostat
slowly, turning the dial
clockwise to increase
temperature or counter
clockwise to decrease temperature, then
activate faucet handle for 20 seconds to
bring in fresh water to be heated at the new
setting. Allow 5-7 minutes for water to reach
new temperature.
PROPERTY DAMAGE
I I
Regularly inspect the unit for any signs of
leakage. If there are signs of water damage,
immediately remove the unit from service.
I I
To avoid water damage from leakage,
replace all cut, loose or split tubing.
I I
A drain pan, plumbed to an appropriate
drain or outfitted with a leak detector,
should be used in those applications where
any leakage could cause property damage.
Covers all replacement parts and labor to correct defects in material or workmanship in the dispenser system for the full
warranty period from the date of installation. The warranty includes parts and labor, provided the service is performed by an
InSinkErator ® Factory Authorized Service Center. If the dispenser is replaced rather than repaired, the warranty on the new unit
shall be for the duration of the remaining portion of the original dispenser's warranty. Note: Warranty is determined by unit
serial number and/or date of installation. Purchase or installation receipt may be required to verify warranty status. When
service is required, and for the location of your nearest factory authorized service center, call toll free 1-800-845-8345 .
The foregoing warranty does not apply to damage or inoperation resulting from accident, alteration, misuse, abuse,
improper installation, installation not in accordance with these instructions or local electrical and/or plumbing codes. We do
not assume any responsibility for consequential damage. Install using genuine InSinkErator manufactured components only.
Use of non InSinkErator components will void the warranty.
Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitations of incidental
or consequential damages, so the above limitations or exclusion may not apply to you. This warranty gives you specific legal
rights, and you may also have other rights which vary from state to state.
8

CARE AND USE

Electric Shock Hazard: To prevent electrical shock, disconnect power before
servicing unit. Use only a properly grounded and polarized electric outlet.
approx. 200°
Scalding Hazard: Do not allow
water to boil. May result in
severe burns.

WARRANTY INFORMATION

1-year warranty on dispenser & tank
CLEANING THE FAUCET AND TANK
I I
Only use mild cleaners to clean the
dispenser's faucet and plastic components.
I I
Cleaners with acids, alkaline, and organic
solvents will result in deterioration of the
plastic components and void the warranty.
SEASONAL STORAGE/DRAINAGE
Anytime the instant hot water dispenser is not used for
extended periods of time, unplug and drain unit. If it is
below freezing you will need to unplug the unit and drain it.
I I
Disconnect power from unit.
I I
Push hot water dispenser faucet lever and
allow water to flow until it is cool.
I I
Shut the cold water supply off at the valve.
I I
If drain screw equipped, locate and
remove from bottom center of water
tank and drain the water into empty pail.
I I
Empty the tank and then reinstall
drain screw onto tank bottom, turning
until snug. Do NOT over tighten.
I I
If drain screw not equipped,
disconnect water supply tubes, remove
tank and invert to drain. Remount tank.
I I
To place back in working order, fill tank
with water and re-connect the plug.