Emerson Insinkerator C1300 Owner's Manual page 2

WHAT YOU SHOULD KNOW BEFORE YOU BEGIN
I I
For your satisfaction and safety, read all instructions, cautions, warnings and dangers before installing or using this
instant hot water dispenser.
I I
Make sure that all electrical wiring and connections conform to local codes.
I I
A standard 120-volt grounded electrical outlet is required for the dispenser's electrical power.
I I
The wall outlet powering the dispenser must have power supplied to it continuously.
I I
It is recommended that a dedicated control valve be installed on the cold water line supplying water to this system.
I I
If you suspect elevated levels of chlorine in your water, it is recommended to use our water filtration system.
I I
Moving parts inside the tank causing a rattling noise is normal.
Equipment Required:
I
Drill
I
T-fitting
I
Dedicated control valve
I
Adjustable wrench
Equipment You May Need:
I I
Anchors for drywall
I I
Hole saw
C1300
H778
2
Foodservice Equipment
Instant Hot Water Dispenser
Installation, Care & Use Manual
IN THIS PACKAGE
1-1/2" Extension Rubber O-Ring
4" Extension
Fiber Gasket
I
Phillips and flat blade screwdrivers
I
Pencil
I
Tape measure
I
Level
I I
Basin wrench
I I
Hole punch
Semi-circular
Mounting Plate
Hex Nut
Semi-circular
Mounting Plate
Hex Tool
3/4" Screws (2)
Wing Nut 3/4" Screws (2)