Emerson Insinkerator C1300 Owner's Manual page 4

2
INSTALLING THE FAUCET - C1300
A
Property Damage: Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
B
Make sure to use rubber O-ring
to ensure proper seal.
C
An assistant may be needed
to hold the faucet in place
while securing the dispenser.
D
Semi-circular mounting plate should
encircle all descending tubes and
extend beyond sink hole when tight.
4
C1300
I I
Unpack dispenser components.
I I
On a firm, flat surface, carefully
straighten the copper tubing.
C1300
I I
Ensure that the black O-ring is
properly seated in the base of the
faucet (the groove on the underside
of the faucet base).
C1300
I I
Feed tubes down through the hole
in the sink or countertop until the
base is at rest on the sink or
countertop surface.
C1300
I I
From under the sink, place the
semi-circular mounting plate onto
the threaded stud.
I I
Place hex nut onto the threaded stud.
Ensure faucet is at desired angle.
I I
Insert screwdriver into hole on side of
hex tool (creating a "T"), and use tool
to tighten nut and secure faucet.