Advanced Option - Mitsubishi Electric MDT55IS User Manual

OSD screen functions (continued)

ADVANCED OPTION

INPUT RESOLUTION
* For the RGB3, RGB4, and OPTION (CAT5) inputs only.
If the monitor fails to recognize the input signal resolution
correctly, you can select a proper resolution manually.
Only when a signal having a resolution close to any of the
following values from three groups, the values in the most
appropriate group are selectable.
Group 1: AUTO, 1024 x 768, 1280 x 768, 1360 x 768
Group 2: AUTO, 1400 x 1050, 1680 x 1050
Group 3: AUTO, 1600 x 1200, 1920 x 1200
BLACK LEVEL EXPANSION
* For the RGB1 (HDMI-MODE: HDMI-HD), RGB2 (DVI-
MODE: DVI-HD), OPTION (SDI), DVD/HD, VIDEO<S>,
and VIDEO inputs only.
Select the level of black expansion from OFF, MIDDLE, and
HIGH.
INPUT CHANGE
You can select the time for input switching from QUICK and
NORMAL.
NOTE: When you select QUICK, slight noise may appear.
SCAN MODE
* For the RGB1 (HDMI), DVD/HD, VIDEO<S>, and VIDEO
inputs only.
You can select the image display area.
OVERSCAN: About 95% of the input image is displayed.
UNDERSCAN: Almost 100% of the input image is
displayed.
SCAN CONVERSION
* For the RGB1 (HDMI), DVD/HD, VIDEO<S>, and VIDEO
inputs only.
You can select the IP conversion mode.
PROGRESSIVE: Interlace signals are converted into
progressive signals. Select this setting for
normal cases.
INTERLACE: Interlace signals are displayed without
being converted. Though this setting is
suitable for motion images, still images
aren't displayed properly.
FILM MODE
You can select the fi lm mode function.
AUTO: Images of 24 frames per second are detected,
subjected to interpolation, and then displayed.
OFF: The input video signals are displayed without being
subjected to any processing.
NOTE: When FILM MODE is AUTO, set SCAN CONVERSION
to PROGRESSIVE. See page 55.
IR CONTROL
You can lock the wireless remote control.
Select from the following 4 modes using the
buttons and then determine the selected mode by pressing
the SET button.
NORMAL: All the remote control operations are
enabled.
PRIMARY: The fi rst MDT551S monitor of those multi-
connected via RS-232C is designated as
PRIMARY.
SECONDARY: MDT551S monitors other than the fi rst
one multi-connected via RS-232C are
designated as SECONDARY.
LOCK: All the remote control operations are
disabled.
NOTE: When you hold down the DISPLAY button on the
wireless remote control for at least 5 seconds, the
NORMAL mode is activated.
You can lock the wireless remote control
independently from the control buttons on the rear
of the monitor. See page 57.
CP MODE
You can enable the double-speed clear picture function (CP
mode).
Moving images displayed at 60 frames per second are
interpolated into 120-frame-per-second images for smooth
and sharp image quality.
OFF: Not interpolated
MIDDLE: Interpolated (Typical)
HIGH: Interpolated (for smoother and sharper image)
NOTE: Frame interpolation may cause noise and smear. To
reduce noise and smear, select OFF.
English-55
and