Table of Contents
Advertisement
Keypad
The Phoenix has a 3 button Keypad on the lower front of the unit, Down, Up and Power. A LED on the keypad indicates
the power state of the Phoenix
Using the Power Button
Press the Power ( ) button for 5 seconds to put the Phoenix 104 into Suspend mode. In Suspend mode, the Phoenix 104
continues to supply power to all memory, but turns off power to most hardware. When you press the Power button to turn
the Phoenix 104 back on, the computer resumes where it was when you turned it off.
You can configure the Phoenix 104 to suspend if not used for a specified period of time by going to Start > Settings > the
System tab > Power > the Advanced tab.
When a Phoenix 104 is suspended and resumes, the 802.11 connection requires re-authentication. This can take anywhere
from 3 seconds to several minutes depending on your systems re-authentication requirements.
Status LED
The Phoenix uses three brightness levels on the green status LED to indicate the status of power and operation.
LED State
OFF
Dim
Blinking
Adjusting the Screen Brightness
To adjust the screen brightness
• Press UP button to increases the brightness.
• Press Down button to decreases the brightness.
You can also adjust the brightness settings by going to Start > Settings >
Control Panel > Backlight. Move the track bar pointer to the volume level
desiered.
Adjusting the Volume
To adjust the volume
• Press and hold the Power button then press the UP button to increases the
volume. The computer will play the Default Sound at the new volume setting.
• Press and hold the Power button then press the Down button to decreases the
volume. The computer will play the Default Sound at the new volume setting.
You can also adjust the volume settings by going to Start > Settings > Control
Panel > Volume & Sounds.
DP_104_User Rev -
Down Up
Figure 3
Status
Not connected to a power source or the power source is off.
Connected to a live power source, unit is in the suspend state.
Unit running
Power
Page 8
Advertisement
Table of Contents
