Upgrading The Phoenix 104 Software; Download The Upgrade Files; Make The Upgrade File Accessable To The Phoenix 104 Computer; Upgrading The Phoenix 104 Using A Usb Storage Device - Percon Phoenix 104 User Manual

Upgrading the Phoenix 104 Software

When you upgrade the Phoenix 104 software, you are updating the operating system (OS), the Summit radio driver
and SCU, and the Percon specific software.
There are three steps involved to upgrade your Phoenix 104 computer:
1. Download the upgrade file from the Percon website.
2. Make the upgrade file accessable to the Phoenic computer. This can be done by
a. Attaching a USB External storage device, such as a USB Memory Drive, USB External Hard Disk, or
USB External Card reader. This is the recommended approach.
b. Downloading the file via an Ethernet connection to put the upgrade file on the internal SD memory
card.
c. Using a shared drive on the network.
3. Use the Percon Image Updater to install the software on the Phoenix Flash Memory.

Download the upgrade files

1 Start your web browser and go to the Percon web site at www.Percon.com.
2 Go to Support > Downloads.
3 Select Phoenix 104 from the list.
4 Download the file onto the local computer, external storage device, or shared network drive to be used for the upgrade.

Make the upgrade file accessable to the Phoenix 104 computer

If using an external memory device, simply plug it into one of the Phoenix USB ports. Verify the connection by going to
Start->Programs->Windows Explorer. The External USB storage device should show as a "Hard Disk".
If using a file downloaded on the internal SD Memory Card, verify the file by going to Start->Programs->Windows
Explorer and clicking on the Storage Card. Navigate to the folder where the file was stored.
If using a network shared drive, go to Start->Programs->Windows Explorer and click on Network. Navigate to the network
shared drive to where the file was stored.

Upgrading the Phoenix 104 Using a USB storage device

To upgrade the operating system
1. Go to Start->Programs->Percon->ImageUpdater
2. Click the Browse button and navigate to where the update file is located and click on the file, then click OK.
3. Make sure that "Failsafe NK.BIN Update" is selected.
4. Click "Update". The update progress is shown on the bottom of the update window.
5. Once the update is complete, close the update window and remove the external storage device.
6. Reboot by going to Start->Programs->Percon->Software Reboot.
DP_104_User Rev - Page 19