Table of Contents
Advertisement
Tap on the KeyWedge Status Icon and the KeyWedge main window appears.
Taping on the File menu allows three options.
Exit will terminate KeyWedge.
Options shows the Configuration Option dialog box.
Hide will cause KeyWedge to run in background mode and only show the System Tray Status Icon.
Configuring KeyWedge
To configure KeyWedge, simply select the Com port based on the voltage needed for your scanner. Set the serial settings
to be the same as your scanner.
The Send Char by Char checkbox determines if the data from the scanner forwarded as keyboard characters one character
at a time or if multiple characters are sent.
Once the configuration is set, tap OK, then OK on the confirmation message box. Then on the File menu, tap Hide.
Verify that your scanner is working by opening any application that accepts keyboard data, such as WordPad, then scan a
barcode label and the data will appear in the application
Increasing MemoryStorage
You can use an SD card to increase file storage and install software. The Phoenix 104 currently supports SD cards that hold
up to 2 GB of information. The SD card slot is located on the top of the Phoenix 104 under the left top cover. See the
Installation manual on how to install a SD memory card.
Once installed, the SD Memory card is treated by WinCE as a Hard Disk. You (or your application) can use the SD
Memory as you would any Hard Disk or USB flash drive.
DP_104_User Rev -
Page 11
Advertisement
Table of Contents
