Zanussi ZFC627WAP User Manual page 8

Problem
There is too much frost and ice
The lid doesn't close completely There is excessive frost
The lid is difficult to open
It is too warm in the freezer
It is too cold inside the freezer
The appliance does not work at
all. Neither cooling nor lighting
works
8
Possible cause
Products are not wrapped properly
The lid is not shut properly or do not
close tightly
The temperature is not set correctly.
The water drainage plug is not cor-
rectly positioned
The lid gaskets are dirty or sticky
Food packages are blocking the lid
The lid gaskets are dirty or sticky
The valve is blocked
The temperature is not set correctly.
The lid does not close tightly or it is
not shut properly
Before freezing the appliance was not
precooled sufficiently
Large quantities of food to be frozen
were put in at the same time
Food placed in the appliance was too
warm
Products to be frozen are placed too
closely to each other
The lid has been opened often
The lid has been opened for a long
time.
The temperature is not set correctly.
Plug is not connected to the mains
socket properly
Power does not reach the appliance
The appliance is not switched on
There is no voltage in the mains socket
(try to connect another appliance into
it)
Solution
Wrap the products better
Check if the lid closes well and the gas-
kets are undamaged and clean
Set a warmer temperature
Position the water drainage plug in the
correct way
Eliminate excess frost
Clean the lid gaskets
Arrange the packages in the right way,
see the sticker in the appliance
Clean the lid gaskets
Check the valve
Set a lower temperature
Check if the lid closes well and the gas-
ket is undamaged and clean
Pre-cool the appliance for enough time
Wait some hours and then check the
temperature again. Next time insert
smaller quantities of food to be frozen at
any one time.
Allow food to cool to room temperature
before storing.
Place the products in a way so that cold
air could circulate among them
Try to not open the lid often
Do not leave the lid open longer than
necessary
Set a warmer temperature
Connect the mains plug properly
Try connecting another electrical device
to the power outlet
Switch on the appliance
Call an electrician