Checking And Adjustment Of Throttle Wire; Adjusting The Differential Lock - Husqvarna Rider 20 ProFlex Operator's Manual

Checking and adjustment of the throttle
wire
Check that the engine responds to the throttle
control and that the correct engine speed is
achieved at full throttle.
If in doubt, contact the service workshop
If necessary the following adjustment can be made:
1. Release the clamping screw and push the
throttle control to full throttle position.
2. Pull the throttle wire's outer casing to the right
and tighten the clamping screw.

Adjusting the differential lock

The differential lock (on the left) is adjusted as
follows:
1. Make sure the differential lock is disengaged,
with the pedal fully raised.
2. Adjust so there is zero play between the outer
cable and the adjuster screw, using the two nuts
on the adjuster screw. You should not feel any
play when you pull the outer cable.
3. Tighten the nuts carefully to avoid damaging the
adjuster screw.
MAINTENANCE
39
English –