CyberGuard SG300 User Manual page 38

Note
You can check that a new network adapter has been installed by clicking Start ->
(Settings ->) Network and Dialup Connections -> Local Area Connection (possibly
followed by a number) -> Properties and ensure the adapter is listed in the Connect
using field.
Set up your PC to connect to the web management console
Note
The following steps assume you want to set up your CyberGuard SG appliance in
bridged mode, so that it sits between your PC and the LAN, transparently filtering
network traffic.
If you want to set up your CyberGuard SG appliance for NAT mode or to connect directly
to your ISP, refer to the User Manual on the CyberGuard SG CD (\doc\UserManual.pdf).
The CyberGuard SG appliance ships with initial network settings of:
IP address:
Subnet mask:
Next, modify your PC's network settings to enable it to communicate with the
CyberGuard SG appliance.
Click Start -> (Settings ->) Control Panel and double click Network Connections.
Right click on Local Area Connection (or appropriate network connection for the newly
installed PCI appliance) and select Properties.
Select Internet Protocol (TCP/IP) and click Properties.
Getting Started
192.168.0.1
255.255.255.0
34