Cyberguard Sg Gateway Appliance Quick Setup; Cyberguard Sg Rack Mount Appliance Quick Setup - CyberGuard SG300 User Manual

CyberGuard SG Gateway Appliance Quick Setup

Unpack the CyberGuard SG appliance
Check that the following items are included with your CyberGuard SG appliance:
Power adapter
CyberGuard SG CD
Network cable
On the rear panel of the CyberGuard SG appliance you will see network, serial and
possibly USB ports, a Reset/Erase button, and a power inlet.
The front panel of the CyberGuard SG appliance contains activity LEDs (lights) that vary
slightly between models. These provide information on the operating status of the
CyberGuard SG appliance.
Note
Power is ON when power is applied (use only the power adapter packaged with the unit).
System/Heart Beat/TST flashes when the CyberGuard SG appliance is running.
Initially, all appliance models except for the SG300 also have all other front panel LEDs
flashing.
If these LEDs do not behave in this manner before your CyberGuard SG appliance is
attached to the network, perform a factory reset. Press the black Reset/Erase button on
rear panel twice within two seconds to restore factory default settings. If the LEDs are
still not flashing after 30 seconds, you may need to contact customer support.
Set up a single PC to connect to the CyberGuard SG appliance
The CyberGuard SG appliance ships with initial network settings of:
LAN IP address:
Getting Started
192.168.0.1
12