Connect To A Home Network; Create Wireless Connection With Automatic; Ip Address; Create Wireless Connection With Static Ip Address - Philips MCi500H/05 User Manual

4 Connect to a
home network
Before you connect the MCi500H to a router:
• Ensure that the PC meets the minimum
requirements. (see 'PC connection
requirements' on page 33)
You can choose one of these modes of
connection:
• Wireless connection with automatic IP
address (see 'Create wireless connection
with automatic IP address' on page 11)
• Wireless connection with static IP address
(see 'Create wireless connection with static
IP address' on page 11)
• Wired connection with automatic IP
address (see 'Create wired connection
with automatic IP address' on page 12)
• Wired connection with static IP address
(see 'Create wired connection with static
IP address' on page 12)
Create wireless connection
with automatic IP address
This chapter shows you how to create a
wireless connection to a home network with
automatic IP address.
1
Ensure that your encryption key (if
required) is available.
2
Ensure that your wireless access point or
wireless router with broadband Internet
access is turned on.
3
Ensure that the MCi500H is turned on.
4
On the MCi500H, pess MENU.
5
Press or , then to select[Settings] >
[Network ].
6
Press or to select[Wireless ].
7
Press .
8
Press or , then to select network.
• Enter encryption key with the remote
control, then press OK /
continue (if required).
9
Press or , then to select [Automatic]
> (Apply settings?) [Yes].
The MCi500H displays a confirmation
»
screen that the settings are saved.
Create wireless connection
with static IP address
This chapter shows you how to create a
wireless connection to a home network with
static IP address.
1
Ensure that your encryption key (if
required) is available.
2
Ensure that your wireless access point or
wireless router with broadband Internet
access is turned on.
3
Ensure that the MCi500H is turned on.
4
On the MCi500H, press MENU.
5
Press or , then to select[Settings] >
[Network ].
6
Press or , then to select[Wireless ].
7
Press or , then to select network.
• Enter encryption key with the remote
control, then press OK /
continue (if required).
8
Press or , then to select[Static].
9
Press the alphanumeric buttons to enter
the static IP address, then press .
10
Press or , then to select (Apply
settings?) [Yes].
The MCi500H displays a confirmation
»
screen that the settings are saved.
to
to
EN
11