Introduction
AC Power Connections
1-4
1.4.
Hardware Overview and Function
The BA series consist of two power connections (motor power and input power), four
potentiometers, a 10-position DIP switch, an enable LED indicator lamp, and a 25-pin
"D" style connector. Refer to Figure 1-3 for locations.
Motor Connections
Enable L.E.D.
Dip Switch
Tach Pot
Balance Pot
Connector P1
Figure 1-3.
1.4.1. Motor and AC Power Connections
The three phase motor terminal connections are made at connections A, B, and C. This
area is designated as such on the amplifier.
Input power to the BA series amplifier is made at the HI (line) and LO (neutral) terminals
with earth ground connected to
grounding stud on the heat sink.
Aerotech, Inc.
BA10/20/30 Series User's Manual
Amplifier Hardware
(ground). Motor frame and shield connect to a
Power L.E.D.
Input Pot
Gain Pot
Version 1.6