Selecting Remote Control Storage Slots - Sentry DCC02 Installation And User Manual

System Commissioning - Programming Remotes System Commissioning - Programming Remotes
As shown on the previous page, pressing and releasing the LRN button, switches
the system into remote programming mode. A single beep indicates this.
When in learn mode, the current slot selected is slot 1. To advance to the next slot,
press LRN again to advance the slot number to slot 2. When a slot is selected, and
unoccupied, the STATUS LED will be off, if a slot is occupied, the STATUS LED will
be lit. This aids the user in avoiding active memory locations when adding new
remote controls.
LRN
Press and release
LRN button
If no remote control is learnt into
the system within 15 seconds,
the system will return to normal
operation, which is signaled
with an error beep!
If you inadvertently enter learn
mode, simply allow the system
to time-out and return to normal
operation after the 15 second
delay.
If the product is used in the
vicinity where many other
remote controls are active, we
recommend that the slot 1 be
skipped. This will help prevent
unintended learning of
transmitters in the area.
x1
Slot 1 (Default)
Slot 2
Slot 15
Slot 16 (Last)
38
LEARN MODE
LRN
x1
Press and release
LRN button
LRN
x1
Press and release
LRN button
LRN
x1
Press and release
LRN button