Fitment To Other Door Types (Krazi-Door, Etc - Sentry DCC02 Installation And User Manual

Motor Head Unit Installation Motor Head Unit Installation
Tightening the motor unit on a door with side plates
For KRAZI DOOR (and other similar doors) it is
necessary to fabricate a steel baseplate and use
it in conjunction with the supplied u-bolt. This
configuration is the only acceptable one - not
doing this exactly as shown will lead to product
failure which is not covered by warranty!
Using steel bar, as indicated in "Required Tools and Equipment",
fabricate a steel baseplate with the following dimensions:
Notes:
Ensure all holes are drilled correctly- if they are too small it will be difficult to install
the u-bolt assembly with this baseplate.
Use of material thinner than 5mm is not recommended as it will distort and fatigue
due to the forces the door exerts on this part.
(KRAZI-DOOR, etc..)
12.5mm
25mm
48.5mm
PLATE THICKNESS = 5~7mm
22
DIA TO SUIT TEK SCREW USED
70mm
97mm
DIA = 10mm