Culligan Gold Series Owner's Manual page 13

4. Regeneration Interval - This setting is active in meter or
Aqua-Sensor mode if the time clock backup DIPswitch #
10 is set to on. The display will show "REGEN" icon and
"dAYS" as well as the numbers to change. Adjust the value
with the "+" or "-" keys.
Pressing the "Status" key will save the setting and move to
the next programming step.
5. Hardness Setting (flow meter only) - This setting is used to set the hardness (grains) of the influent
water supply. The display will only appear if a flow meter is connected to the circuit board. The dis-
play will first show "Hard" for two seconds and then display the Hardness default (or the previously
programmed value). Adjust the value with the "+" or "-" keys.
(These settings will not get saved to EEPROM until the 'status' key is pressed while at the 'dEFLtS'
programming step)
6. Iron Setting (flow meter only) - This setting is used to set
the iron level (PPM) of the influent water supply. The dis-
play will show "Iron" in the left most digits and the iron
default setting (or the previously programmed value) in
the far right digit. The display will only appear if a flow
meter is connected to the circuit board. Adjust the value
with the "+" or "-" keys.
Pressing the "Status" key will temporarily store the setting and move to the next programming step.
7. Salt Type (flow meter only) - This setting is used to select the regeneration salt type (Sodium
Chloride or Potassium Chloride). The display will show "SALt" for 2 seconds. Then display the
default 'NACL'. Pushing the "+" or "-" keys will change to 'KCL'.
SALE
Pressing the "Status" key will temporarily store the setting and move to the next programming step.
8. Efficiency Mode (flow meter only) - Efficiency mode will
only be active if the conditions as explained in
Familiarization section are met (Not available if DIP switch
#6 or DIP switch #9 are on). The "EFFICIENCY MODE"
Icon will be displayed with a default of "YES". Toggle
between "YES" and "NO" with the "+" or "-" key.
Pressing the "Status" key will temporarily store the setting and move to the next programming step.
IRON O
NACL
EFFICIENCY MODE
YES
KCL
13