Table of Contents
Advertisement
Implementing Programs
Implementing Programs
Program Execution
Once the program has been entered it can be set
running by depressing the 'RUN/HOLD' push button on
the front.
With the run initiated, the program will commence and
the legend on the display will indicate if a ramp or dwell
is being performed. While a program is running the short
scroll will contain a third parameter "TIME." Push scroll
button once; time remaining for the current segment,
either ramp or dwell will be indicated. If the loop counter
has been set to any value other than one, then the
above procedure will be repeated for each loop.
At the end of the complete program, an "E" will appear
on the display.
Parameter Change While Running
The previous parameters can be inspected but not
changed while a program is running. If it is necessary to
alter a parameter while a program is running, the pro-
gram must be placed into the hold condition. To put
program into hold, push run/hold button once. After
modification of the parameter, returning the program to
the run state will cause the program to continue with the
changed value(s) installed. Push run/hold button again to
restart program.
Loop Count
If the loop count is set to values other than one, then the
number of loops remaining in a running program can be
displayed. To determine which loop is being performed
depress scroll button until LR' is displayed and by
pushing either the up or down button the remaining
number of loops, excluding the one being executed, is
displayed.
Program Hold
A running program can be forced into hold at any stage
by depressing the "RUN/HOLD" push button on the front.
When a running program is forced into hold, "HOLD"
legend will appear on the display together with the
27
Hide quick links:
Advertisement
Table of Contents
