Humidity Level Adjustment - ClimateMaster ATC32U01 iGate User Manual

AT C 3 2 U 0 1 C o m m u n i c a t i n g , P r o g r a m m a b l e T h e r m o s t a t - U s e r M a n u a l

4.0 Humidity Level Adjustment

NOTE 1: The thermostat must be confi gured by installer for
humidity control to access the humidity setpoint(s).
To adjust the Relative Humidity level on your thermostat,
use the left/right arrow buttons to select the RH user
option on the Home Screen and then press the center
button. The Humidity Control screen shows either one (with
Humidifi cation or Dehumidifi cation enabled alone) or both
(with BOTH enabled) humidity setpoints. Adjust the setpoints
using the up/down arrow buttons. Press the center button to
save changes.
• Humidifi cation Setpoint (default 40%): options:
10% to 45% (in 5% increments)
NOTE: Humidifi er must be installed to set humidifi cation
setpoint.
• Dehumidifi cation Setpoint (default 60%):
options: 45% to 80% (in 5% increments)
NOTE 2: The thermostat forces a 10% "dead-band" between
the Humidifi cation and Dehumidifi cation setpoints.
While adjusting the Dehumidifi cation setpoint,
the Humidifi cation setpoint may be automatically
reduced to enforce a 10% "dead-band". However,
the Dehumidifi cation setpoint will not be
automatically increased to enforce a 10% "dead-
band" while adjusting the Humidifi cation setpoint.
The maximum range for the Humidifi cation setpoint
may be limited by the Dehumidifi cation setpoint.
NOTE 3: If an outdoor sensor is present, the Humidifi cation
setpoint will be calculated automatically for optimal
comfort.
10/12/11 5:22 PM
FAN AUTO
HUMID ON
RH 38%
°
70
AUTO
SETPOINT
HEAT 70
COOL 78
MODE FAN MENU
TEMP
RH
HUMIDITY CONTROL
%
42
HUMIDITY
HUMIDITY SETTING 40%
DEHUMID SETTING 60%
R e v. : 2 J u l y, 2 0 1 2
5