Table of Contents
Advertisement
5. rinse these parts thoroughly in solvent,
then dry with compressed air or let air
dry.
do not soak the spray gun body in
solvent. prolonged exposure to sol-
vent will rapidly deteriorate the spray
gun washers and seals.
note: If the small holes in the atom-
izing cap become blocked, soak the
cap in clean solvent. If the blockage
still exists, clear the blockage with a
small needle, taking great care to not
enlarge or damage the hole. Damage
to the hole will create a disrupted spray
pattern.
6. use an old tooth brush and solvent to
clean the inner orifice and other hard to
reach areas on the outside of the gun
body.
7. Wipe the gun body dry with a lint free
shop towel.
Model t23092 high-pressure spray gun
lubrication
Lubricate the following areas shown in
figure 14 with a non-silicon spray gun
lubricant after each cleaning.
a. Fluid Control Knob
b. pattern Control
c. Air Valve packing
d. Atomizing Cap threads
e. trigger pin
Allow the lubricant to coat threads and run
into the gun body to lubricate all moving
parts and seals.
B
A
figure 14. Lubrication locations.
C
d
e
-11
-
Advertisement
Table of Contents
