Grizzly T23088 Instructions

For questions or help with this product contact Tech Support at (570) 546-9663 or techsupport@grizzly.com
Introduction
this engine cleaning gun is used to effectively
spray those hard to reach areas of grease and
grime. the Model t23088 features an 8" wand,
quick-release tank, and a standard
EyE/EAR INJURy hAzARD!
Wear goggles and NOISh-
approved respirator when
using this tool!
Always disconnect tool from
air to prevent unexpected
operation during service!
DO NOT EXCEED 90 pSI!
personal
occur.
Do not spray flammable
fluids near and open flame
or ignition source.
Always wear a respirator
when using this tool and
use in a well ventilated
area.
Specifications
Air inlet size ............................................
Air Consumption ....................................... 4 CFM
operating Air pressure range ........... 30–90 psi
Wand length .................................................... 8"
Fluid Container Volume .............................. 1 pint
Weight (empty) ......................................... 1.1 lbs.
WARNING: NO pORTION Of ThIS MANUAL MAy bE REpRODUCED IN ANy ShApE
OR fORM WIThOUT ThE WRITTEN AppROvAL Of GRIzzLy INDUSTRIAL, INC.
⁄ " npt inlet.
1
4
INJURy hAzARD!
injury could
EXpLOSION hAzARD!
LUNG hAzARD!
⁄
1
4
Copyright © MArCh, 2011 By grizzly industriAl, inC.
#ts13997 printed in ChinA
ENGINE CLEANING GUN
Increase Fluid
Operation
1. Fill the fluid container with an approved
engine cleaning solvent or detergent. never
use corrosive fluids in the container.
2.
Connect the gun body to the fluid container,
then connect the gun to an air supply set at
60 psi.
3.
put on personal protective equipment, then
hold the gun so the nozzle is 6–10" from the
surface and squeeze the trigger.
4. rotate the nozzle, as shown in figure 1, to
adjust the amount and pattern of spray. lock
the setting by tightening the rear thumb wheel
against the nozzle.
5. When you are done, fill the fluid container
" npt
with clean water and squeeze the trigger until
the gun sprays clear water.
Important: Consult local Disposal Agencies for
the proper disposal of solvent and waste
fluids.
MODEL T23088
INSTRUCTIONS
gun Body
nozzle
Decrease Fluid
Fluid Container
figure 1. Model t23088.