STAR TRAC FITNESS P-UB Owner's Manual page 14

Carefully position the seat frame over the seat carriage on the bike
frame, aligning the attachment holes in the sides of the seat frame
with the holes in the seat carriage.
Using the 6mm hex wrench and four M10 X 10 socket head screws,
secure the seat frame to the seat carriage. Tighten all four screws
securely.
It may be necessary to have one person support and position
the display console while a second person makes the cable connec-
tion.
Carefully slide the display console neck approximately one inch onto
the neck brackets of the bike frame. With the console partially sup-
ported by the neck brackets, plug the display console cable into the
receptacle on the bike frame.
Be careful not to pinch your fingers between the console
neck and the bike frame when sliding the console into place.
Be sure not to pinch the display cable between the con-
sole neck and the bike frame.
Carefully slide the console neck onto the neck brackets until it is fully
seated. Secure the display console to the frame with four M6 X 16
socket head screws (two screws in front side and two screws in back
side). Using the 4mm hex wrench, tighten all four screws securely.
Install the pedals on the pedal cranks using a multi-end wrench or a
5/8-inch open-end wrench. Tighten the pedals securely.
Turn the left pedal spindle counterclockwise when threading
into the crank arm; turn the right pedal spindle clockwise when thread-
ing into the crank arm.
14 STAR TRAC P-SERIES BIKES O ' G
WNER S UIDE