Operating Instructions; Seat Adjustments - STAR TRAC FITNESS P-UB Owner's Manual

Place the bike on the floor in the position in which it will be used. Use the leveling adjusters (located on the underside of the
front and rear feet) to compensate for uneven floor surfaces and to eliminate wobbling.
If needed, the arm rest angle may be adjusted by turning a screw
under the arm rest. Using the 3mm hex wrench, turn the screw clock-
wise to lower or counterclockwise to raise the arm rest angle. Both
arm rests should be adjusted to the same angle, slightly above level.
You have now completed assembly of your STAR TRAC P-SERIES
RECUMBENT BIKE.
O
PERATING
Operating the STAR TRAC P-SERIES BIKE is very easy. Simply mount the bike, begin pedaling, and press QUICK START. Learning
the features and incorporating the STAR TRAC P-SERIES BIKE into your members' fitness programs is just as easy. In this chapter,
you will learn the display function and how to get the most out of every STAR TRAC P-SERIES BIKE workout.
: Before operating the bike, you must be familiar with the following equipment limitations:
I
Maximum Weight: Your STAR TRAC P-SERIES BIKE is designed for a maximum user weight of 350 lbs/159 kg. DO NOT
exceed the maximum user weight.
S A
EAT DJUSTMENTS
Proper seat positioning helps ensure maximum exercise efficiency and comfort, while reducing the risk of injury. Always adjust the seat
position prior to beginning your workout.
: When adjusting the seat height for either bike, your knee should never completely "lock out" during any portion of the cycle
pattern.
When sitting on the seat of your P-SERIES Upright Bike, your knees should be
almost fully extended when the pedals are at the lowest point of their rotation.
To adjust the seat height:
When raising the seat, the seat will ratchet up when pulled.
When lowering the seat, you must use the seat release knob.
With the pedal at its lowest point of rotation, stand on the pedal with
your knee slightly bent. To raise the seat, carefully lift up on the "nose"
of the saddle and raise the seat to the desired position (the seat
release knob does not need to be pulled out). To lower the seat, care-
fully pull out on the seat release knob (located at the rear of the seat
tube) and lower the seat to the desired position. Release the knob,
ensuring that the spring retracts to its original position, and that the
seat stays firmly in place.
Note your height adjustment (shown on the front of the seat post) for
future reference. This number is the highest number visible on the
seat post.
STAR TRAC P-SERIES BIKES O
I
NSTRUCTIONS
' G
WNER S UIDE
15