STAR TRAC FITNESS P-UB Owner's Manual page 12

Carefully slide the seat post into the seat tube.
Pull out on the seat release knob, and slide the seat post fully into the
seat tube. Release the seat release knob.
Install two M4 X 20 socket head screws into the seat sleeve to secure
it. Tighten the screws securely using the 3mm hex wrench.
Install the M6 X 10 socket head screw with star washer into the hole
in the back of the seat tube. Using the 5mm hex wrench, tighten the
screw securely.
It may be necessary to have one person support and position
the display console while a second person makes the cable connec-
tion.
Carefully slide the display console neck approximately one inch onto
the neck brackets of the bike frame. With the console partially sup-
ported by the neck brackets, plug the display console cable into the
receptacle on the bike frame.
Be careful not to pinch your fingers between the console
neck and the bike frame when sliding the console into place.
Be sure not to pinch the display cable between the con-
sole neck and the bike frame.
Carefully slide the console neck onto the neck brackets until it is fully
seated. Secure the display console to the frame with four M6 X 16 flat
head screws (two screws in front side and two screws in back side).
Using the 4mm hex wrench, tighten all four screws securely.
Install the pedals on the pedal cranks using a multi-end wrench or a
5/8-inch open-end wrench. Tighten the pedals securely.
Turn the left pedal spindle counterclockwise when threading
into the crank arm; turn the right pedal spindle clockwise when thread-
ing into the crank arm.
12 STAR TRAC P-SERIES BIKES O ' G
WNER S UIDE