The Rear Panel - At A Glance - Agilent Technologies N8700 User Manual

1 Quick Reference
The Rear Panel – At a Glance
5 4
1 – AC input connector
2 – DC output connector
3 – Analog
programming
connector
4 – SW1 setup switch
5 – Remote Sense
connector
6 – GPIB connector
7 – LAN connector
8 – USB connector
9 – Ground screw & nut
WARNING
12
6 7 8
150V – 600V
(wire clamp)
8V – 100V
(bus bar)
3
Header with mating plug-in connector for both the 3.3 kW and 5 kW output models.
A 3-conductor plug is provided for single-phase VAC.
A 4-conductor plug is provided for 3-phase VAC.
Wire clamp connector is used for 150V, 300V and 600V models.
Bus bars are used for 8V to 100V models.
Connector for the analog interface. Includes output voltage and current limit
programming and monitoring signals, Shut-Off control (electrical signal),
Enable/Disable control (dry-contact), power supply ok (Power Supply OK) signal and
operation mode (CV/CC) signal. (See next page for details)
Nine-position switch for selecting remote programming and monitoring modes for
Output Voltage, Current Limit and other control functions. (See next page for details)
Connector for making remote sensing connections for regulating the load voltage and
compensating for wiring voltage drop. (See next page for details)
Connector for connecting to a GPIB interface. See chapter 4 for setup.
Connector for connecting to a LAN interface. LINK LED indicates link integrity. TX LED
indicates LAN activity. See chapter 4 for LAN setup.
Connector for connecting to a USB interface. See chapter 4 for setup.
M4x8 screws with nut for making chassis ground connections
SHOCK HAZARD The AC power cable provides a chassis ground through the
ground conductor. Be certain that your power source is three-conductor for
single-phase models or four-conductor for 3-phase models with the ground
conductor (green/yellow) connected to earth ground.
9
2-phase VAC
(three-conductor)
3-phase VAC
2 1
(four-conductor)
Series N8700 User's Guide