Alpine CDA-105Ri Owner's Manual page 42

<JAPANESE CAR>
This unit
iPhone/iPod Connection (sold separately)
Connect USB cable to an iPhone/iPod with Interface cable for
iPod.
Interface cable for iPod (supplied)
Remove the iPhone/iPod
Remove the iPhone/iPod from Interface cable for iPod.
• After changing the unit to a source other than the USB iPod, remove
the iPhone/iPod. If the iPhone/iPod is removed in the USB iPod
mode, data may cause damage.
• If sound is not output or the iPhone/iPod is not recognised even when
the iPhone/iPod is connected, remove the iPhone/iPod once, then
connect it again, or reset the iPod.
• Do not leave the iPhone/iPod in a vehicle for a long time. Heat and
humidity may damage the iPhone/iPod and you may not be able to
play it again.
40
-EN
Front Frame
Screws (M5 × 8)
(Included)
Mounting Bracket
USB cable
USB memory Connection (sold separately)
Connect USB memory
1. Connect the USB cable to the USB connector of the unit, and
then secure the connection using the lock case supplied with
USB cable as shown below.
This unit
2. Connect USB memory to USB cable.
This unit
USB Connector
Remove USB memory
Pull out USB memory squarely from the USB cable.
This unit
USB Connector
• When removing USB memory, pull it out straight.
• If sound is not output or USB memory is not recognised even when
USB memory is connected, remove USB memory once, then connect
it again.
• Change to a source other than the USB memory mode, then remove
the USB memory. If the USB memory is removed in the USB memory
mode, data may be damaged.
• Route the USB cable away from another cables.
USB memory
(sold separately)
lock case
USB memory
(sold separately)
Cable (supplied)
USB memory
(sold separately)
Cable (supplied)