Nortec HP Series Installation And Operation Manual page 35

Media Installation
The recommended way to install the media is taking the entire roll and securing its leading edge
to the top of the assembly by working the 1inch screws/studs though the media, see Figure 28:
Mesh Installation. Then carefully rolling it downward until it reaches the bottom of the duct. Cut
the media at the bottom of the assembly to fit. Once cut, go back and work the rest of the
screws through the media. If the recommended method cannot be followed, use a flat, clean
surface to pre-cut the media. Be sure to cut the media with precision so not to be short on the
final section of the assembly.
Figure 28: Mesh Installation
Media Clamping Strip Installation
The final step is to secure all components of the assembly using the media clamping strip.
Place the strips so the 1 inch screw/studs pass through the slotted holes on the media
clamping strip then fasten a factory supplied nut to hold the assembly in place. See Figure 29:
Clamping Strip Installation.
Figure 29: Clamping Strip Installation
HP Series Installation Manual | 32