FCC NOTIFICATION This equipment has been tested and found to comply with the limits a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a commercial installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Overview Feature Installtion Procedures Installation Notes Operation Front Panel Selection Channels Scan Channels Set Scan Rate Hot Key Mode Hot-key Activation Select A Computer Channel by Number Select A Computer Channel by Using Arrow Keys Scanning Channels Set Scan Rate Change Hot-key Mode Activator Exit Hot-key Mode Hot-key Command Table...
By having only one keyboard, monitor, and mouse, you reclaim your desktop while saving time and money. SwitchMan uses the same bulletproof design as Raritan's professional-grade products and is available in two-channel and four- channel models.
∗ Powered by connected compuers ∗ Use Raritan's premium, tangle-proof cables for highest resolution video requirements ∗ Use inexpensive, industry standard KVM cables for typical applications. Figure 2. SW2 (back panel, vertical position) Figure 3. SW4 (back panel, horizontal position)
2. Using either end of the KVM cables, connect the keyboard, monitor, and mouse connectors to the section marked PC 1 on the SwitchMan back panel. (See figure 2 for SW2 or figure 3 for SW4) Note: With Raritan's tangle-proof KVM cables, each connector is...
Installation Notes ∗ Switchman computer ports are PS/2 style. You may also connect AT- style computers. Use Raritan keyboard/mouse port adapter “APSAT” on PS/2 cables to plug into a computer with “AT” keyboard port and serial mouse port. ∗ Switchman converts keyboard and mouse signals to PS/2 and requires...
Operation You can select a computer from the front panel of SwitchMan or through the keyboard in hot-key mode. The LEDs on the front panel of SwitchMan indicate which computer, or channel, is currently selected and ready for SwitchMan automatically senses which channels are active-that is, those that have computers that are connected and powered ON.
Scanning channels In hot-key mode, press the <s> key to activate Scan. The LED above the scan button is illuminated, and SwitchMan begins scanning active channels. Set Scan rate You can change the default Scan rate to an interval from 1 to 99 seconds. The LED above the most recently selected channel buttons blinks twice to acknowledge the change, and scanning starts at the new rate.
Hot-key command table TASKS KEY STROKES Activate hot-key mode Exit hot-key mode Increment channel number Decrement channel number Select channel number Enter + (n) + Toggle Scan ON/OFF Set Scan rate + (n) + Enter Make Num Lock the hot-key mode activator Enter Num Lock Make Scroll Lock the hot-key mode activator...
Troubleshooting The following table lists probable solutions for problems that may be encountered during SwitchMan installation or operation. Trouble Probable Cause Solution Symptom No front panel Bad connection(s) Check cable connection(s) LEDs Computer not Power ON computer powered ON Not enough power to run Notebook computer or Guardian device SwitchMan.
Page 14
PC channel in the back of SwitchMan and restart the computers. If the problem persists, contact dealer. For Raritan technical support, either go to: www.raritanonline.com Or call your local reseller or distributor...
Warranty One year Specifications of Cables Use Raritan's premium, tangle-proof cables or Raritan's standard cables* Raritan premium, tangle-proof cables: One cable required for each PC CSWT18 6' cable for PS/2 and VGA connections CSWT30 10' cable for PS/2 and VGA connections...
Need help?
Do you have a question about the SwitchMan SW2 and is the answer not in the manual?
Questions and answers