Assembly - Fisher Labs CZ-21 QuickSilver Operating Manual

ASSEMBLY

Your Fisher CZ-21 requires little assembly. Handle it carefully, care
for it regularly, and it will give you years of dependable service.
1. Remove the headphone, handle and search coil
assemblies from the box. Be careful not to put any strain
on the cable connections.
2. Adjust the lower stem to the approximate length you
will be using: extended for stand-up use or as short as
possible for diving. To extend the lower stem, push in the
spring lock, pull out the lower stem and let the spring lock
snap into another hole.
3. Unwind just enough cable to attach the search coil to
the lower stem.
4. Remove the bolt and wing nut from the search coil. Line
up the hole in the lower stem between the two holes in
the search coil "ears." Attach the coil to the stem with
the bolt and wing nut and finger tighten.
5. The arm rest may be repositioned for maximum comfort
by removing the arm-rest screw, sliding the arm rest to the
next screw hole and re-inserting the arm-rest screw.
Control Housing
Control Panel
Target I.D. Decal
Foam Hand Grip
Adjustable Arm Rest
Arm-rest Screw
Figure 2. CZ-21 Quicksilver Detector.
Battery Access Panel
Fiberglass Upper Stem
Fiberglass Reinforced
Nylon Lower Stem
7-foot Search Coil Cable
Headphone
Submersible
Headphones
8-inch
Spider
coil
Nylon
Wing Nut
Plug
5